FACTORY-AUTHORIZED ENERGY LOGIC · HEATERS & BOILERS
Waste Oil Heater & Boiler
REPAIR & MAINTENANCE
Burning used oil for heat? Our factory-trained techs repair burners, nozzles, preheaters, fuel pumps, and combustion controls on waste oil heaters and boilers on-site at your facility.
45+ Years in Industrial Cleaning
BURNERS, NOZZLES, COMBUSTION — HANDLED.
H2O Power Equipment repairs waste oil heaters and boilers in Denver and Colorado Springs as a factory-authorized service center for EnergyLogic. We service burners, nozzles, preheaters, fuel pumps, and combustion controls — with mobile on-site repair within a 300-mile radius.
AUTHORIZED SERVICE CENTER: ENERGYLOGIC
Sound Like Your Heater?
Burner won’t ignite / no flame
Ignition electrodes, transformers, photocells, and control primaries. A heater that won’t light is our most common waste oil call — we diagnose the ignition circuit and get flame back.
Nozzle clogging or dirty burn
Waste oil is hard on nozzles. We clean, rebuild, and replace nozzles and preheaters so the burner atomizes properly and burns clean instead of coking up.
Oil won’t pump or feed
Fuel pumps, oil lines, filters, and preheater blocks that gum up on dirty oil. We rebuild the fuel side so oil flows to the burner at the right temperature and pressure.
Smoking, sooting, or short cycling
Combustion out of tune, dirty heat exchanger, or air-band and draft problems. We clean and re-tune combustion so the unit runs efficiently and passes a clean burn.
Boiler won’t hold temperature / no heat
Aquastats, circulators, zone valves, and heat exchanger issues on oil-fired boilers. We service the heat and hydronic controls to restore steady output.
Lockouts, faults, or dead controls
Primary controls, thermostats, limit switches, and wiring faults that lock the unit out. We troubleshoot the control system safely, in-shop or on-site.
Not on the list? If a waste oil heater or boiler does it, we’ve fixed it. Describe the problem and we’ll take it from there.
Waste Oil Heater Brands We Repair.
Factory-Authorized Service Center
We Also Service
🔥 Burning used oil for heat? We service burners, nozzles, preheaters, fuel pumps, and combustion controls across the units we repair.
On-Site Heater & Boiler Repair.
Waste oil heaters and boilers are serviced exclusively on-site — they’re ceiling-hung or plumbed into your shop, so our factory-trained techs bring the shop to you. Our fully stocked trucks and factory schematics allow most repairs to be done in a single visit.
Fully Stocked Trucks
Our mobile fleet carries the burner, nozzle, and combustion parts most repairs need — so we fix it on the first trip.
Factory Schematics On Hand
As an EnergyLogic authorized service center, our techs work from manufacturer specs right at your unit.
Done In One Visit
Ignition, nozzle, fuel-pump, and combustion work completed at your facility — no removing an overhead heater.
300-Mile Coverage
Dispatched from Denver & Colorado Springs across Colorado and into southern Wyoming.
Heater down before a cold snap? Get on the schedule now — most on-site repairs are completed in a single visit.
Request On-Site Service →Before, During & After the Repair.
Get Ready for Winter
An end-of-season tune-up — nozzle, combustion, and fuel-system service — means your heater fires on the first cold day instead of failing when you need it most.
Learn More About Preventive Maintenance →Keep It Burning Clean
Ask about nozzles, filters, and burner parts for your unit so it fires reliably and burns clean all season long.
Shop Heater Parts →Beyond Repair?
When a heater’s too far gone to be worth fixing, we’ll say so — and as an authorized EnergyLogic dealer, we can price a replacement right away.
Shop Waste Oil Heaters →Rocky Mountain Region
On-Site Service Across Colorado & Wyoming.
Coverage Map
Factory-certified mobile service within a 300+ mile radius across Colorado and southern Wyoming.
Physical Showrooms
Got Questions?
WASTE OIL EQUIPMENT REPAIR FAQS
We do. H2O Power Equipment is a factory-authorized EnergyLogic service center with shops in Denver (Commerce City) and Colorado Springs and mobile repair within 300 miles, and we service heaters and boilers of most other makes too.
Usually an ignition problem — worn electrodes, a failed transformer, a dirty photocell, or a primary-control fault — or a clogged nozzle and cold/contaminated oil. We diagnose the ignition and fuel circuits and restore a clean flame.
Combustion out of tune, a clogged nozzle or preheater, or a heat exchanger that needs cleaning. We clean and re-tune so it burns clean and efficient.
Yes — waste oil heaters and boilers are serviced exclusively on-site. Because these units are ceiling-hung or plumbed into your shop, our factory-trained techs come to you rather than bringing equipment in. Our fully stocked mobile trucks cover a 300-mile radius from Denver and Colorado Springs, across Colorado and into southern Wyoming.
Yes. A pre-season tune-up — nozzle, combustion, and fuel-system service — is the best way to make sure it fires on the first cold day instead of failing when you need heat most.
IS YOUR MACHINE DOWN?
Get Your WaSTE OIL EQUIPMENT SERVICED.
"*" indicates required fields